rev. d m154107 ZX47-60+ ZX47-60ln+ edr-7797u edr-7797/2re urj/rav 151215 page 1 of 4 operating temperature -40c to 85c storage temperature -55c to 100c dc power: max. voltage 5.7v max. current 120ma internal power dissipation 0.73w input power +15dbm case style: hn1173 notes: 1. the negative slope indicates that output voltage decreases as input power increases. see "output voltage vs input power" graph below. 2. temperature sensor output provides a dc output voltage which increases linearly with temperature rise. recommended minimum load for this port is 2 k?. 3. recommended minimum load at dc out port is 100 ?. see maximum ratings for no damage. connectors model sma ZX47-60-s+ sma ZX47-60ln-s+ maximum ratings electrical specifcations (t amb = 25 c) ? low noise (output ripple) for ZX47-60ln+, 20mvp-p typ. @ 10mhz ? high dynamic range ? wide bandwidth ? single supply voltage: +5v ? stability over temperature ? built-in temperature sensor ? protected by us patent 6,790,049 features ? rf/if power measurements ? low cost power monitoring system ? rf leakage monitors ? fast feedback levelling circuits ? rf power control ? receiver rf/if gain control ? rssi measurements applications ZX47-60+ ZX47-60ln+ power detector 50?, -60dbm to +5dbm, 10 to 8000 mhz coaxial output voltage vs input power @ +25c 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 2.2 -60 -50 -40 -30 -20 -10 0 10 input power (dbm) output voltage (v) 8000 mhz 6000 mhz 5000 mhz 2000 mhz 1000 mhz 10 mhz outline drawing simplifed functional diagram rf in 1 dc out 5 vcc (+5v) 2 temperature sensor 4 ground 3 coaxial connections output load=1000 ? freq. (mhz) dynamic range at 1db error (dbm) output volt. range (v) slope (mv/db) (note 1) vswr (:1) pulse response time (nsec) typ. temp. sensor output slope (mv/c) (note 2) dc operating power vcc (volts) note 3 current (ma) min. max. typ. typ. typ. typ. ZX47-60+ ZX47-60ln+ typ. min. typ. max. typ. rise fall rise fall 10 1000 -55 to 0 0.50 - 2.10 -25 1.1 400 10 800 400 2.00 4.5 5.0 5.5 100 1000 5000 -60 to -5 1.8 5000 6000 -55 to +5 1.7 6000 8000 -50 to +5 1.4 permanent damage may occur if any of these limits are exceeded. temp sensor out rf in vcc d c o ut temperature sensor a b c d e f g h j k 1.20 .69 .46 1.12 .04 .34 .46 .28 .33 .21 30.48 17.53 11.68 28.45 1.02 8.64 11.68 7.11 8.38 5.33 outline dimensions ( ) inch mm l m n p q r s t wt. .18 .14 .94 .50 .35 .18 .106 .60 grams 4.57 3.56 23.88 12.70 8.89 4.57 2.69 15.24 31.8 note: when soldering the dc connections, caution must be used to avoid overheating the dc terminals. see application note an-40-10 . ! notes a. performance and quality attributes and conditions not expressly stated in this specifcation document are intended to be excluded and do not form a part of this specifcation document. b. electrical specifcations and performance data contained in this specifcation document are based on mini-circuits applicable established test performance criteria and measurement instructions. c. the parts covered by this specifcation document are subject to mini-circuits standard limited warranty and terms and conditions (collectively, standard terms); purchasers of this part are entitled to the rights and benefts contained therein. for a full statement of the standard terms and the exclusive rights and remedies thereunder, please visit mini-circuits website at www.minicircuits.com/mclstore/terms.jsp mini-circuits ? www.minicircuits.com p.o. box 350166, brooklyn, ny 11235-0003 (718) 934-4500 sales@minicircuits.com +rohs compliant the +suffix identifies rohs compliance. see our web site for rohs compliance methodologies and qualifications
page 2 of 4 power input deviation from ideal vs output voltage @ freq 2000mhz -65 -55 -45 -35 -25 -15 -5 5 15 0.5 0.7 0.9 1.1 1.3 1.5 1.7 1.9 2.1 output voltage (v) input power (dbm) -2.0 -1.5 -1.0 -0.5 0.0 0.5 1.0 1.5 2.0 p.in dev. from ideal (db) ideal measured deviation from ideal power input deviation from ideal vs output voltage @ freq 6000mhz -65 -55 -45 -35 -25 -15 -5 5 15 0.5 0.7 0.9 1.1 1.3 1.5 1.7 1.9 2.1 output voltage (v) input power (dbm) -2.0 -1.5 -1.0 -0.5 0.0 0.5 1.0 1.5 2.0 p.in dev. from ideal (db) ideal measured deviation from ideal power input deviation from ideal vs output voltage @ freq 8000mhz -65 -55 -45 -35 -25 -15 -5 5 15 0.5 0.7 0.9 1.1 1.3 1.5 1.7 1.9 2.1 output voltage (v) input power (dbm) -2.0 -1.5 -1.0 -0.5 0.0 0.5 1.0 1.5 2.0 p.in dev. from ideal (db) ideal measured deviation from ideal output voltage change vs freq over temperature range -40 -30 -20 -10 0 10 20 30 40 0 1000 2000 3000 4000 5000 6000 7000 8000 frequency (mhz) output voltage change (%) -40c +25c +85c @ in p wv2qgfo wvrwvqnvcgcpgugs xg6gorgcvwg4cpg -40 -30 -20 -10 0 10 20 30 40 0 1000 2000 3000 4000 5000 6000 7000 8000 frequency (mhz) output voltage change (%) -40c +25c +85c @ in p wv2qgfo 2qg+prwvgxcvqpqo+fgcnu wvrwvqnvcggs -65 -55 -45 -35 -25 -15 -5 5 15 0.5 0.7 0.9 1.1 1.3 1.5 1.7 1.9 2.1 output voltage (v) input power (dbm) -2.0 -1.5 -1.0 -0.5 0.0 0.5 1.0 1.5 2.0 p.in dev. from ideal (db) ideal measured deviation from ideal notes a. performance and quality attributes and conditions not expressly stated in this specifcation document are intended to be excluded and do not form a part of this specifcation document. b. electrical specifcations and performance data contained in this specifcation document are based on mini-circuits applicable established test performance criteria and measurement instructions. c. the parts covered by this specifcation document are subject to mini-circuits standard limited warranty and terms and conditions (collectively, standard terms); purchasers of this part are entitled to the rights and benefts contained therein. for a full statement of the standard terms and the exclusive rights and remedies thereunder, please visit mini-circuits website at www.minicircuits.com/mclstore/terms.jsp mini-circuits ? www.minicircuits.com p.o. box 350166, brooklyn, ny 11235-0003 (718) 934-4500 sales@minicircuits.com performance curves ZX47-60+ ZX47-60ln+
page 3 of 4 slope vs input power over temperature range @ freq 10mhz -30 -25 -20 -15 -10 -5 0 5 -60 -50 -40 -30 -20 -10 0 10 input power (dbm) slope (mv/db) -40c +25c +85c slope vs freq over temerature range @ input power -50dbm -30 -25 -20 -15 -10 -5 0 1000 2000 3000 4000 5000 6000 7000 8000 frequency (mhz) slope (mv/db) -40c +25c +85c slope vs input power over temperature range @ freq 5000mhz -30 -25 -20 -15 -10 -5 0 5 -60 -50 -40 -30 -20 -10 0 10 input power (dbm) slope (mv/db) -40c +25c +85c slope vs freq over temerature range @ input power -25dbm -30 -25 -20 -15 -10 -5 0 1000 2000 3000 4000 5000 6000 7000 8000 frequency (mhz) slope (mv/db) -40c +25c +85c slope vs input power over temperature range @ freq 8000mhz -30 -25 -20 -15 -10 -5 0 5 -60 -50 -40 -30 -20 -10 0 10 input power (dbm) slope (mv/db) -40c +25c +85c slope vs freq over temerature range @ input power -5dbm -30 -25 -20 -15 -10 -5 0 1000 2000 3000 4000 5000 6000 7000 8000 frequency (mhz) slope (mv/db) -40c +25c +85c notes a. performance and quality attributes and conditions not expressly stated in this specifcation document are intended to be excluded and do not form a part of this specifcation document. b. electrical specifcations and performance data contained in this specifcation document are based on mini-circuits applicable established test performance criteria and measurement instructions. c. the parts covered by this specifcation document are subject to mini-circuits standard limited warranty and terms and conditions (collectively, standard terms); purchasers of this part are entitled to the rights and benefts contained therein. for a full statement of the standard terms and the exclusive rights and remedies thereunder, please visit mini-circuits website at www.minicircuits.com/mclstore/terms.jsp mini-circuits ? www.minicircuits.com p.o. box 350166, brooklyn, ny 11235-0003 (718) 934-4500 sales@minicircuits.com performance curves ZX47-60+ ZX47-60ln+
page 4 of 4 vswr vs freq over temperature range 1.0 1.4 1.8 2.2 2.6 3.0 0 1000 2000 3000 4000 5000 6000 7000 8000 frequency (mhz) vswr -40c +25c +85c temperature sensor voltage vs ambient temperature 0.3 0.4 0.5 0.6 0.7 0.8 0.9 -60 -40 -20 0 20 40 60 80 100 ambient temperature (degc) sensor voltage (v) output voltage change vs input power over temperature range -50 -40 -30 -20 -10 0 10 20 30 40 50 60 70 -60 -50 -40 -30 -20 -10 0 10 input power (dbm) output voltage change (mv) output voltage deviation @-40c relative to +25c output voltage deviation @+85c relative to +25c @ freq 2000mhz notes a. performance and quality attributes and conditions not expressly stated in this specifcation document are intended to be excluded and do not form a part of this specifcation document. b. electrical specifcations and performance data contained in this specifcation document are based on mini-circuits applicable established test performance criteria and measurement instructions. c. the parts covered by this specifcation document are subject to mini-circuits standard limited warranty and terms and conditions (collectively, standard terms); purchasers of this part are entitled to the rights and benefts contained therein. for a full statement of the standard terms and the exclusive rights and remedies thereunder, please visit mini-circuits website at www.minicircuits.com/mclstore/terms.jsp mini-circuits ? www.minicircuits.com p.o. box 350166, brooklyn, ny 11235-0003 (718) 934-4500 sales@minicircuits.com performance curves ZX47-60+ ZX47-60ln+
|
